Wavell Light
This is a collection of the most frequently asked questions about the Wavell Light
If, contrary to expectations, you can't find the answer you're looking for, please feel free to send us a message using the contact form below.
Specifications
SOUND
Sensitivity
110±3 dB
Frequency
20–20,000 Hz
Impedance
16Ω
GENERAL
Bluetooth Name
Wavell Light
Range
10 meters
IPX rating
IPX5
Weight of headphones (2 pairs)
7g
Weight case
30g
BATTERY
Earphones:
Playback time
5 hours
Charging time
60 minutes
Capacity
35 mAh
Case:
Number of charges for TWO
3 times
Charging time
90 minutes
Capacity
250 mAh
Charger input
USB-C
Power Input
5V DC
TECHNOLOGY
Bluetooth version:
Bluetooth 5.2
Instructions
QUICK START
1. Put your Wavells in the case
2. Wait about 2 seconds (until the indicator lights up)
3. Take your Wavells out of the case and wait for the light to start flashing.
4. Connect to “Wavell Light” in your Bluetooth settings.
5. Play some music and enjoy your new Wavell Light
CHARGING
There are two ways to charge the Wavell Light:
1. Using a USB-C charging cable plugged into the USB-C port on the case.
2. Via wireless charging, where the coil is located at the bottom of the case, which means it must be placed upright (with the lid on top). When the case is placed on a wireless charger, it will charge wirelessly.
One thing all charging methods have in common is that the indicator light on the front will start to glow.
RECOVERY
1 Open case
2 Unpair the devices to which the headphones are connected.
3 Pick up both earbuds (they must NOT be connected to anything).
4 Tap one of the earbuds 3 times.
5 The headphones should then emit a bright light for a few seconds.
6 Once the headphones are constantly lit, they should be restored and can be reconnected to your device.
7 You may want to try this 2–3 times to make sure the restoration was done correctly.
Still not sure?






